Skip to content
Etobicoke Plumbing ServicesProper plumbing, politely done.

Fixtures

Kitchen Faucet Installation in Etobicoke

A new kitchen tap is one of the quickest ways to freshen the room, and fitting it properly means it will not drip into the cupboard below.

  • Fault found before anything is cut
  • Options and trade-offs explained plainly
  • Joints tested under pressure or full flow
  • Floors protected, work area left clean
Call now(365) 816-2905

No forms, no call centre.
Ask for a plumber.

Wrench resting in a wet stainless steel kitchen sink
A wrench left in the sink bowl mid-way through a faucet swap.

Quick call

(365) 816-2905
Hours
Phones answered 24/7
Area
All of Etobicoke
Call now

Telltale signs: kitchen faucet installation

People replace a kitchen tap for many reasons: a dripping spout that has outlived its cartridge, a pull-down sprayer that has lost its spring, a new countertop with different holes, or simply a style that suits a renovation.

What we bring

  • Cartridges, stems, seats, O-rings and repair kits
  • Quarter-turn stops and compression sleeves
  • Differential pressure gauge and seat tools

Tested before we leave

  • Valve cycled fully open and closed
  • Hot and cold checked at the right sides
  • Drips watched for ten minutes

On the job: what we open, clear and test

We close the stops under the sink, disconnect the supplies and remove the old tap, which often means freeing corroded mounting nuts in a cramped cupboard. The deck is cleaned and the new faucet set with the correct gasket or sealant for the sink material. New braided supply lines are fitted, and if the old angle stops are stiff or weeping, we replace them on the spot rather than leave you with a weak link.

Pull-down hoses are checked for full travel without catching on the trap or disposal, and the counterweight placed where it moves freely. We run hot and cold, check for leaks at every connection, and flush the aerator.

What can change the job

  • Number of holes in the sink or counter versus the new tap
  • Stone countertops that need a new hole drilled
  • Seized valves or old compression fittings
  • A garbage disposal or filter faucet sharing the space
  • Touchless models that need a power outlet or batteries

If you are replacing a shower valve or bathroom taps at the same time, our shower valve page covers that side.

Etobicoke homes and this job

Older kitchens across Etobicoke often have galvanized or early copper stubs behind the sink with stops that have not been turned in decades. Newer houses in Woodbridge and north Etobicoke usually have better access but builder-grade taps reaching the end of their life.

Buying your own? We are glad to install it. Check the box for the number of holes it needs and whether a deck plate is included.

Before you call

Take a photo under the sink and count the holes. Ring (365) 816-2905. If you are also planning basement work, have a look at our page on the basement flooding subsidy.

Other jobs on the same truck

Asked at the basement stairs

Can you install a faucet I already bought?

Yes. We will check it suits your sink before starting.

How long does it take?

Mostly a morning's job or less; new stops or drilling stone add time.

One call, and a plumber is on the way

Give us the street and the symptom. We will talk you to the right shut-off while the van heads over.

Call now(365) 816-2905
Call now · (365) 816-2905